Aluminum Cleaner
Description

A revolutionary product that is safe and environmentally friendly. It will clean and brighten your Pontoon tubes from top to bottom without ACIDS, safely and effectively.
USED ON BARE ALUMINUM ONLY. NOT FOR POLISHED, ANODIZED OR CAST ALUMINUM.
Without scrubbing, just spray on and pressure wash off. See the dramatic difference JJV’S BEST Aluminum Cleaner makes:

DIRECTIONS:
Do not dilute. If beauty plate is anodized, protect with plastic. DO NOT MIX WITH OTHER CLEANERS this will neutralize the product. For use on bare only. Not to be used on painted aluminum. Using a NEW or clean Hudson Sprayer or Garden Sprayer working from BOTTOM to TOP, spray an even coat of product on surface. It should look like shaving cream. If not, mist until foam starts. If cleaning pontoons, do one tube at a time. Allow to dwell on the bare aluminum 5 to 8 minutes. Do not let dry. Keep misted with product. Cover every square inch with a high pressure washer, from TOP to BOTTOM.
Rinse under the deck rub rail until water has no foam and is clear.
Rinse behind the beauty plate until water is clear.
When tube is drying, if you see an area with white chalking, use a rag and water and wipe off. If this dries, you’ll need to wet a rag with product (wear rubber gloves) and wipe and rinse well.
Please note that heavily soiled areas may require repeating.
NOT FOR POLISHED, ANODIZED OR CAST ALUMINUM
20′ and under pontoons with two tubes takes 4 quarts or 1 gallon. Tri tubes will use 5 or 6 quarts. Questions on how much your Pontoon will need please go to the contact page and email us, or you can call us at 763-479-3145.
To clean the rest of the boat inside and above the water line use our boat wash.
KEEP OUT OF REACH OF CHILDREN.
Demonstration
Aluminum Cleaner FAQ’s
NOTE: Will not remove heavy lime. Pressure wash every square inch.
How to Clean the Tubes of Pontoons and Bare Aluminum Boats Using JJV’s Best Aluminum Cleaner
Use with a NEW Hudson sprayer. DO NOT MIX WITH OTHER CLEANERS. This will neutralize the cleaner. USE STRAIGHT. Not for polished, anodized or cast aluminum. Spray the bare aluminum from bottom to top, one side a time. Allow to dwell 5-8 minutes making sure you have even foam. Do not allow product to dry. Power wash from the top down. Be sure to rinse well behind the brackets. Wipe dry or allow time to air dry. When drying, if you see white chalking, wipe with wet towel or power wash more. This is the old oxidation. Heavily soiled areas may require repeated spraying. Protect any anodized aluminum.
Please call us with any questions. It’s likely we’ve encountered your situation at some point and are happy to help you do the best job possible with your cleaning. JJV’s Best has other cleaners and solutions for a variety of cleaning situations.